Using the RS 220

Using the RS 220

To switch the product on and to listen to your audio source, proceed as follows:

Sequence of steps

Page

1.

Make sure that the rechargeable batteries are charged.

14

 

 

 

2.

Switch your audio source on.

–

 

 

 

3.

Switch your transmitter on.

16

 

 

 

4.

Switch your headphones on.

19

 

 

 

5.

Select the desired audio source.

21

 

 

 

6.

Put on the headphones.

15

 

 

 

7.

Adjust the desired volume on the headphones.

23

 

 

 

Switching the transmitter on/off

Switching the transmitter on

￿Touch the Power touch key F.

The transmitter switches on. The LED of the last selected audio source (here COAXIAL) lights up. The ON LED G flashes until the transmitter has found suitable headphones and then lights up continuously.

ON

G

F

If the transmitter doesn’t receive an audio signal for more than 3 minutes, it switches, depending on the setting, to either standby mode or loop through mode. If the transmitter receives an audio signal within the next 10 minutes, it automatically switches on again.

16 RS 220