Putting the S1 DIGITAL into operation
Pairing the headset with a Bluetooth deviceThe following chapter describes, by way of example of a mobile phone, how to pair the headset with a Bluetooth device.
Make sure that–the headset is connected to the
–the mobile phone’s Bluetooth visibility is enabled (see the instruction manual of the corresponding Bluetooth device),
–the headset is placed close to the mobile phone (approx. 50 cm or 19.7”).Switch the headset on by setting the Power OFF/ON switch G to the position ON.Press and hold the
until the
LED alternately flashes blue and red.On your audio source, activate the Bluetooth function “Add a new device”.When the mobile phone prompts for a password or PIN code, enter the default PIN code “0000”.
Proceed as described in the instruction manual of the mobile phone.Once the headset has found the mobile phone, the devices exchange device identification information. The 
LED flashes 3 times blue. You hear an ascending beep. The devices
have identified each other and the headset is paired with the mobile phone.
If no device is found within approx. 5 minutes, the 
LED flashes 3 times red and you hear a descending beep. The headset will then try for 3 minutes to connect to one of the up to 8 previously paired Bluetooth devices. If this fails, the Bluetooth function automatically switches off after 10 minutes.
In this case, repeat the necessary steps to pair the headset with the mobile phone again.
S1 DIGITAL 13