Shark MV2010 manual Using Vacuum Mode

Vacuum Mode

After inserting the telescopic handle, your cleaning system is vacuum-ready. Begin vacuuming your hard-surface floors by tilting the cleaning unit back and pressing the vacuum power button.

1

2

USING VACUUM MODE

1Pull and twist the quick release cord holder to unwrap the power cord completely. Plug in the unit.

2To vacuum, slide the toggle switch until the vacuum power button is exposed. Press the vacuum power mode button to the ON “I” position.

IMPORTANT: You cannot use the vacuum function if the frame and pad are attached to the base of the cleaning unit.

NOTE: Only vacuum sealed and non-carpeted bare floor surfaces. Refer to floor manufacturer guidelines and warnings.

MV2010_11_IB_ENG_110103.indd 5

English

3

3Place your foot lightly on the top of the cleaning unit base. Tilt the cleaning unit back. Vacuum your floors.

IMPORTANT: Vacuum all surfaces first before steam-cleaning to avoid condensation build-up. Avoid vacuuming after steam mopping.

NOTE: If you vacuum and then steam-clean one room, before moving on to the next, wait 10 minutes for the condensation to clear before vacuuming again.

www.SharkVacThenSteam.com 5

11-01-03 1:26 PM