Shark S3250 11 manual Using Your Light & Easy Steam Mop

Using Your Light & Easy™ Steam Mop

	When you use your steam mop for the
	first time or if you have not used the unit
	in awhile, it may take a minute or two
1	for the water to travel through the pump
	and into the heater to create steam. Get
	it started by pumping the handle a few
	times. If you have waited a few minutes
	and you still do not see any steam,
	reference the troubleshooting section
fig. 1	on page 12.

fig. 2

fig. 3

English

If your Light & Easy™ Steam Mop stops steaming, it could be out of water. Unplug the power cord from the electrical outlet and refill the water tank at anytime.

fig. 4

fig. 5

IMPORTANT: Your steam mop needs water to make steam! Never use your steam mop without water in the tank.

Sweep or vacuum your floors prior to cleaning with your Light & Easy™ Steam Mop.

Visit www.sharkclean.com for other great quick cleaning products to complement your Light & Easy™ Steam Mop, such as the Shark® Cordless Stick Vac.

1Pull and twist the quick release cord holder to unwrap the power cord completely. (fig. 1) Plug into a 120-volt electrical outlet. (fig. 2) The “On” light will turn blue. If the light does not turn on, reference the troubleshooting section on page 12. (fig. 3)

2Wait 30 seconds for the boiler to heat the water. Pump the handle a few times to prime the pump, activate steam and moisten the micro-fiber pad. (fig. 4)

3Mop with a forward and backward motion to customize steam output automatically. (fig. 5)

6 TOLL FREE: 1-800-798-7398

S3250_instructions_100526.indd 6-7

www.sharkclean.com 7

10-05-27 9:58 AM