Maintenance
Rotating |
Brush |
A 
1Cleaning the Pet Hair Power Brush -
Slide locking latch (A) forward.
Gently tilt brush housing upward to open.
IMPORTANT: DO NOT force; it will not open all the way.
Remove debris from turbine wheel and air passage.
CLEANING THE MOTORIZED FLOOR BRUSH
When your motorized floor brush needs cleaning or locks onto an object, it automatically shuts down to prevent damage to your lifetime belt. The indicator light will illuminate red warning you to turn off the vacuum and clear blockage immediately. The light will reset itself once blockage has been cleared and power has been cycled on/off or vacuum has been locked in the upright position.
1Detach the motorized floor brush from the detachable canister.
2Inspect the opening underneath and the rotating brush. If a
Resetting the Motor Thermostat
Your Shark® Navigator™ Professional Vacuum is equipped with a protective Motor Thermostat. If the motor should overheat, the thermostat shuts off the power.
To reset the Motor Thermostat:
Move the Power Button to the “O” – Off position.
Unplug the vacuum.
Check for clogged hose or filter; unclog hose and replace filter. Refer to Checking for Blockages on page 11.
Wait 45 minutes for vacuum to cool; then plug in the vacuum.
Turn the Power Switch to the “I” – On position to start the vacuum.
Note: If vacuum still does not start, contact Customer Service at:
Ordering Replacement Parts
To order additional parts and accessories, go to www.sharkclean.com
or call 1-800-798-7398.
PART | PART NO. |
|
|
Super Stretch Hose | 152FFJ |
|
|
Dusting Brush & |
|
Crevice Tool | 1115FC |
|
|
Foam & Felt Filters | XFF80 |
|
|
Hepa Filter | XHF80 |
Turbo brush | 137FFJ |
|
|
Cleaning Wand | 114FFJ |
|
|
16" Crevice Tool | 159FFJ |
|
|
12 | TOLL FREE: |
UV420_26_IB_E_120810_3.indd 12
