CAUTION:
•Do notattempt to remove the battery pack from the unit to charge it.
•Never attempt to throw the battery pack or unit into a fire or incinerate it.
•Do notattempt to remove or damage the b attery casing.
TO MAXIMIZE THE LIFE OF YOUR NI-CD BATTERIES
1. Charge for a minimum of 20 hours before initial use. Failure to do so will reduce
the product’s battery life significantly.
2. Do notstore the unit with the charging adaptor attached and plugged in.
3. Only recharge when the batteries are fully discharged (or as close to fully
discharged as possible).
4. Do notstore in areas of high temperatur e or humidity.
5. After three (3) months of storage, the product should be fully discharged and then
recharged to maximize battery power.
6. Use only the charger supplied with the product. If other chargers are used, the
batteries can fail causing damage to the battery, product or personal property.
7. Ni-Cd b atteries have a long useful life but at some time they will need to be
replaced. To purchase replacement batteries and parts visit www.sharkvac.com.
NOTE: If the product has never been used or has been stored for an extended period
of time without use –it will take several complete charge and discharge cycles to
realize the full operational time of your product.
5
OPERATING INSTRUCTIONS
BATTERY REMOVAL & DISPOSAL
NOTE: If uncertain as to how to remove your battery pack, we suggest you take your
sweeper to a reputable small appliance service technician to have this service
performed.
Follow these steps when battery removal is required.
This sweeper is equipped with Ni-Cd batteries and you need to dispose of them properly.
When the batteries are no longer good for use, they must be removed from the sweeper
for disposal. Do notremove the batteries for an y reason other than disposal of them.
Call your nearest recycling center for information on the recycling and disposal of
Ni-Cd batteries.
WARNING: You must never use ordinary batteries for replacement as these may leak
and cause damage. Use only battery pack XBP610N provided for replacement.
8
OPERATING INSTRUCTIONS
Fig. 11
Fig. 10
Fig. 12
CLEANING THE DUST CONTAINER
To achieve the best performance, empty
the dust container after each use.
1. Pull the dust container straight out from the side. (Fig. 10)
NOTE: Be careful not to accidentally turn the unit “On”
2. Empty dust container contents. (Fig. 11) If desired, you may rinse with water to
clean the dust container - but dry thoroughlybefore replacing on the s weeper.
3. Replace dust container on cordless sweeper.
4. Periodically remove the transparent brush cover on the front of the cordless
sweeper and remove any build up of lint, hair or fiber on the rotating brush.
To remove the cover - grip the cover from the bottom, pull out and upward until the
cover unlocks from the side slots and tabs located on the top of the sweeper.
Carefully cut away threads or hair with scissors. (Fig. 12)
CAUTION: Do not accidentally turn unit on while cleaning.
CAUTION: Any electronic or electrical appliance should not be stored in or
exposed to areas of high heat or humidity. Do not store your cordless sweeper
close to stoves, radiators, furnaces or in a bathroom
or bathing area.