Sharp AF-100DX Energy Saver, To Change Air Flow Direction, Exhaust, Touch ENERGY SAVER pad

HOW TO OPERATE

ENERGY SAVER

During normal operation, the thermostat automatically controls cooling and the fan runs continu- ously. When the ENERGY SAVER is selected, the thermostat automatically controls cooling and the fan automatically stops when the compressor is not operating. (Fan will stop 30 seconds after the compressor stops. After the fan stops, the fan is programmed to rotate for approx. 2 minutes to detect room temperature. This will occur within a 20 min time span.)

COOLSELECTORENERGY/FANTEMPTIMERhrF ENERGYSAVERPOWER

SAVERSAVERON/OFFindicatorpadON/OFF

During cooling operation

1	Touch ENERGY SAVER pad.
	• ENERGY SAVER indicator will light.
2	To cancel, touch ENERGY SAVER
	pad again.

• ENERGY SAVER indicator will go off.

NOTE: ENERGY SAVER cannot be set during fan only (HIGH FAN, MED FAN, LOW FAN) operation.

TO CHANGE AIR FLOW DIRECTION

Adjust the louvers to change the direction of air flow for uniform and efficient cooling of the room.

Horizontal louvers	Vertical louvers
Adjusts UP/DOWN air flow	Adjusts LEFT/RIGHT air flow

EXHAUST

If air in your room is stale, set the

EXHAUST lever to the OPEN position.

This will exhaust stale air to the outside.

The EXHAUST lever should normally

be kept in the CLOSED position duringCLOSED EXHAUSTOPENLever cooling for maximum efficiency.

13