Sharp AF-S155NX 1Remove Chassis, 2Install Top Angle and Side Bracket, Assemble Window, 3 Filler Panels

1.Pull down front panel and remove filter. (See FIG. 1).

2.Lift front upwards and place to one side.

FIG. 1

FIG. 2

3.Locate the four front screws and remove. These screws will be needed to re-install the front later. (See FIG.2)

4.Pry away front from cabinet sides as per photo (see FIG.3)

5.Gently lift front off unit and place to one side (See FIG.4).

FIG. 3

FIG. 4

6.Remove shipping crews from top of unit and also on the side by the base if installed.

7.Hold the cabinet while pulling on the base handle, and care- fully remove the unit.

8.Add two foam inserts to holes in top of cabinet where shipping screws were removed from.

1.Attach foam gasket to top angle above holes as shown in FIG. 6.

FIG. 6

2. Install top angle and side retainers

to cabinet as shown in FIG. 6.

1. Place cabinet on floor, a bench, or a table.

2. Slide "I" section of window filler panel into side retainer on the side of the cabinet (see Figures 7-8). Do both sides.

FIG. 7

PLASTIC	WINDOW FILLER
FRAME	PANEL

PANEL