3.Insert top and bottom legs of window filler panel frame into channel in the to angle and bottom rail. Do both sides.
4.Insert washer head locking screws (2) into holes in
top leg of filler panel frame (see Step 6). Do not totally tighten. Allow leg to slide freely. Screws will be tightened after Section 6.
4Place Cabinet in Window
1. Open window and mark center of window stool.
2.Place cabinet in window with bottom stool angle firmly scated over window stool as shown. Bring window down temporarily behind top angle to hold cabinet in place.
STOOL
STOOL
ANGLE
3.Shift cabinet left or right as needed to line up center of cabinet on center line marked on stool.
4.Fasten cabinet to window stool with 2 screws into holes.(You may wish to
5.Add bottom rail seal over screws to window stool.
5Install Support Bracket
1.Hold each support bracket flush against outside of sill, and tight to bottom of cabinet as shown below. Mark brackets at top level of sill, and remove.
MARK 
LEFT | 1/2" LONG SCREWS | |
AND LOCKNUTS | ||
| ||
LOCKNUT |
| |
SILL ANGLE | RIGHT | |
BRACKET |
| |
FLAT HEAD BOLT |
|
2 EACH REQ'D FOR EACH SUPPORT BRACKET
2.Asscmble sill angle bracket to support brackets at the marked position, as shown. Hand tighten, but allow for any changes later.
3.Install support brackets (with sill angle brackets attached) to correct hole in bottom of cabinet as shown.
4.Tighten all 6 bolts securely.
Bottom | 1/2" long screws |
Rail Seal | and locknuts |
3/4" long HEX-
HEAD SCREW