Wall-Mount Bracket Installation
1 | Determine the location where the base bracket will be | Included part |
installed. |
|
(1) Use tape or other means to mark the measured positions on the wall where the display will be installed. The center of the “X” drawn from the four corners of the square marks the center of the panel.
(2) Take the coin with the string and align it perpendicular to the base bracket.
Use a pencil, etc., to mark the two screw hole locations.
Base bracket
| Dimension lines |
|
| used as a guide | Cellophane tape, etc. |
923mm |
| String |
Base |
| |
|
| |
| bracket | Center |
| outline | line |
Display outline
Weight
1572mm
shaped screw holes
Use a pencil, etc., to mark the screw hole position on the wall behind the bracket.
Position the base bracket so that the center of it is aligned with the string.
Cellophane tape, etc.
Position the base bracket so that the perpendicular parts of it are parallel with the string.
*When marking on the wall, use a material that will not leave a permanent mark on the wall and get the approval of the customer before beginning the work.
2 | Tighten the screws | |
Temporarily remove the base bracket from the wall and loosely screw in | ||
| ||
| mm dia. × 2 screws) in the screw hole positions marked on the wall. At this time, the screw | |
| heads should extend more than 4 mm above the wall so that the base bracket can be hung on | |
| the screw heads. Hang the base bracket on the installed screws, check to make sure the | |
| bracket is not sagging to the left or right, and then firmly tighten the screws. Use | |
| screws to secure the remaining screw holes (15 screws). (The screw hole diameter is 9 mm.) | |
| Min. 4mm |
Use the weight with the string used in Step 1 to make sure the bracket is perpendicular.