Sharp AN-CM270 FIGURE 3 ILLUSTRA TION OF SINGLE BEAM CEILING BRACKET INSTALL A TION , FIGURE 4 I NST ALL A T ION OF PLASTIC TRI M ON T HE CEILING BRACKET

PAGE 5
INSTALLATION INSTRUCTIONS CEILING BRACKET AN-CM270
FIGURE 3 ILLUSTRA TION OF SINGLE BEAM CEILING BRACKET INSTALL A TION
DO NOT RUN THE AC POWER CORD THROUGH THE CEILING PLATE AND TRIM COVER
STEP 2. I NSTA LL THE CEILING M OUNT PL AS TIC TRIM
2.1 The Access Hole (See Fig. 4) in the ceiling attachment plate is large enough to accommodate the
molded connectors commonly used the with projector.
2 .2 Audio , Video and o t her lo w vo l t age connecti ons may be passed thr ough t he access hole in t he
ceiling plate and may also be passed through the plastic trim cover. There is a label (See Fig. 4) on
the inside of the plastic trim cover, adjacent to the center mounting bushing.
2.3 Select the contour appropriate for your application and cut out the opening along the line indicated
on the label. Use a very sharp cutting tool.
2.4 Thread the cable through the plastic trim cover. Place the plastic trim cover in place over the
ceiling plate and press the velcro tabs together.
FIGURE 4 I NST ALL A T ION OF PLASTIC TRI M ON T HE CEILING BRACKET
Sheetrock or lath
and plaster cei lin g
1/4 x 10 Lag Bolts Velcro
Ceiling Mounting Bracket
Ceiling Beam
Washers
Cable Access Hole
Access Hole Template Label Press Velcro Tabs together
to secure plastic trim cover
in position