PAGE 7
INSTALLATION INSTRUCTIONS CEILING BRACKET AN-CM270
IF Y OU INTEND TO RUN AUD IO OR VIDEO CAB LES THROUG H THE CEIL ING PLATE
PROCEED WITH STEP 5.1 AND 5.2, OTHERWISE PROCEED TO STEP 5.3:
5 .1 Cu t opening in t he ceiling plate t rim co ver as indica ted on t he label inside cover near
the center bu shing.
5.2 Thread cables through the plastic trim cover.
DO NOT RUN THE AC POWER CORD INSIDE THE PLASTIC TRIM COVER.
ALL WIRING MUST COMPLY WI TH THE NEC AND ALL LOCAL BUILDING,
ELECTRIC, AN D SAFETY CODES.
STEP 5 A T TA CH THE POSITIONING ASSEMBLY TO THE CEILING PL ATE
FIGURE 9 Ceiling Trim Cover Cable Access Hole
Washer
Locking Hex Nut
Upper Knuck le
Assembly
4 . 3 Fold the a tta chment pla te dow n on it s hinge. See Fig. 8
4 .4 Install the M4 knurled thumb scre w b y hand. See Fig. 8. DO NOT USE TOOLS TO
TIGHTEN THIS SCREW.
M 4 Knurled Thumb Scre w
REMIND ER: MAKE SURE TO ALLOW SUFFICIENT SLACK IN THE WIRING TO PERMIT THE
PROJECTOR TO SWING DOWN ON THE HINGE TO ALLOW EASY SERVICING OF THE FILTER
A N D T HE LAMP ASSEMBLY.
FIGURE 8