PAGE 8
INSTALLATION INSTRUCTIONS CEILING BRACKET AN-CM270
6.1 Raise the projec tor w ith the mounting plate attached and slide the fitting (See Fig. 10)
over the support stud on the hanging position.
6 . 2 Replace the locking nut (removed in s tep 3. 1). Using the 9 /1 6” box wrench run t he nu t
up but do not tighten all the way.
FIGURE 10
STEP 6 HA NGING THE PROJECTOR FROM POSIT IONING A SSEMBLY
5.3 Place the plastic trim cover in position over the ceiling plate and press the Velcro
tabs together.
5.4 After completing step #5.3, screw the longer shaft with the locking nut and washer
into the center threaded bushing on the ceili ng pla te as far as it will go. (See Fig. 9 )
5.5 Tighten the locking nut against t he ceiling plate using a 3/4” open end wrench or an
adjustable crescent wrench .
5.6 Tighten the locking nut on the upper knuckle using a 9/16” bo x wrench.
DO NOT RUN THE AC POWER CORD INSIDE THE PLASTIC TRIM COVER.
ALL WIRING MUST COMPLY WI TH THE NEC AND ALL LOCAL BUILDING,
ELECTRIC, AN D SAFETY CODES.
STEP 7 A I M THE PRO JECTOR
7 .1 A ft er t he projec to r has been proper ty w i red, t u rn i t o n and loosen the posi t ionin g
assembly adjustment nuts just enough so that you can move the project or fairly easily.
(See Fig. 11) DO NOT COMPLETELY LOOSEN THE NUTS.
7 .2 Se t t he Horizon tal Centering by loosening the ceiling locking nu t, mo ve t he projec to r to
center t he i mage and tighten the nut. (Use 3/4” open end wrench).
7.3 Set the vertical centering and tighten the lower positioning adjustmen t nut.
(See Fig. 11)
7.4 Set the Horizon tal tilt and tighten the upper positioning adjustment nu t. (See Fig. 11)