!install_ar5316_5320.book 6 ページ ２００３年１２月２日 火曜日 午前９時４２分
INSTALLING THE PRINTER DRIVER
INSTALLATION IN WINDOWS 95/98/Me/NT 4.0/2000
(PARALLEL CABLE)
1 The USB or parallel cable must not be connected to the machine. Make sure that the cable is not connected before proceeding.
If the cable is connected, a Plug and Play window will appear. If this happens, click the "Cancel" button to close the window and disconnect the cable.
Note The cable will be connected in step 12.
2 Insert the
3 
), and then 
).
7 When the interface selection screen appears, select "Parallel" and click the "Next" button.
8 Select the printer port and click the "Next" button.
Select "LPT1" for the printer port.
4 
).
If the language selection screen appears after Note you double click the "setup" icon, select the
language you wish to use and click the "Next" button. (Normally the correct language is selected automatically.)
5 Read the message in the "Welcome"
window and then click the "Next" button.
If you are using Windows 95/NT 4.0, go to step 8.
6 When you are asked how the printer is connected, select "Connected to this computer" and click the "Next" button.
If "LPT1" does not appear, another printer or Note peripheral device is using LPT1. In this case
continue the installation, and after the installation is finished, change the port setting so that the machine can use LPT1. This procedure is explained in "Another printer is using the parallel port (when using a parallel cable)" on page 12.
9 When the model selection window appears, select model name of your machine and click the "Next" button.
For the name of the model that you are using, see "DIFFERENCES BETWEEN MODELS" in the Operation Manual.
10 Click the "Yes" button.
6
