Sharp AR-M350U/M450U Installing procedure flowchart, AR-M350U Unpacking and Installation

=￿￿[6]?702#%UNPACKING-+0)#0&+056#..#6+10￿HOAND￿￿￿￿￿￿￿￿￿￿￿￿￿INSTALLATION￿"#$%&￿￿'

1. Installing procedure flowchart

There are many combinations between this machine and option units. For installing option units, observe the following procedures for efficiency.

To install the devices efficiently, follow the procedure below.

Some peripheral devices may have been installed as standard devices depending on the main unit model.

Part of descriptions and illustrations may be different.

Scanner/document feeder device

Finishing device

Main unit

Scanner/document feeder device

Finishing device

Duplex/bypass device
Finishing device	Main unit

Duplex device Paper feeding device Paper feeding device

Start of installation

Main unit, paper feeding device, and power supply unit.

AR-D13 /AR-DC1

AR-D14 /AR-DC1

Main unit

	Yes	Install duplex/pypass device.
Duplex/bypass
device installed?		AR-DU3
		AR-DU4
No
		Install finishing device.
Finishing device	Yes	AR-MS1/AR-DC1
installed?		AR-FN6 /AR-DC1
		AR-FN7
		AR-PN1A / B / C / D
No

Controller board,	Yes
facsimile unit or other
electric devices
installed?
No

[Electrical setting/adjustment]

1)Installation of driver software, setting, and operation check

Main unit/AR-EF1/AR-NC5J/AR-HD3/ AR-FX5/AR-PK1/AR-NS2/AR-P14

2)Paper guide position adjustment/off center adjustment

AR-D13/AR-D14/ AR-DU3/AR-DU4

End

Install controller board, facsimile unit or other electric devices.

AR-HD3

AR-FX5/AR-MM9

AR-PK1

AR-NS2

AR-NC5J

(Not required for the AR-M350N/M450N)

AR-P14

(Only AR-M350U/M450U)

Extended memory

Scanner/document	Yes	Install scanner/document feeder.
		* AR-EF1 /AR-RK1
feeder installed?
No

When installing a paper feeding device, an optional power supply unit or a duplex/bypass device, be sure to re-attach the rear cabinet, the AC inlet cover, and the harness cover of the main unit at the end of installation as needed.

When installing a controller board, a facsimile unit, and other electric devices, be sure to install them one at a time.

Only off center adjustment is needed for AR-DU3.

*When installing an option, refer to the Service Manual for that option and or the AR-M350 / M450 Service Manual.

AR-M350U UNPACKING AND INSTALLATION 6-1