OPERATING CONTROLS
POWER SWITCH; PRINT / ITEM COUNT MODE SELECTOR:
“OFF”: Power OFF.
“•”: Power ON. Set to the non- print mode.
(“• • • ... • • •
“P”: Power ON. Set to the print mode.
(“• • • ... • • • +P” will be printed.)
“P•IC”: Power ON. Set to the print and item count mode.
The counter will count the
number of times that 
has been pressed in addition.
Notes: • Each time 
is used in subtraction, 1 will be subtracted from the count.
•The count is printed when the calculated result is obtained.
•Pressing of 
, 
or 
clears the counter.
•T h e c o u n t e r h a s a maximum capacity of 3 digits (up to ±999).
If the count exceeds the maximum, the counter will recount from zero.
RATE SETTING MODE SELECTOR:
This selector is used to set the conver- sion rate or the tax / discount rate.
“
”: Set this selector to the “RATE SET” position before storing an each rate.
Conversion rate:
•Enter the conversion rate,
then press 
.
•A maximum of 6 digits can be stored (decimal point is not counted as a digit).
Tax / discount rate:
•Enter the adding tax rate, then press 
.
•To store a discount rate, press 
before pressing 
.
•A maximum of 4 digits can be stored (decimal point is not
4
