Listening to the radio, E-10, QMemorizing a station, QTuning

Listening to the radio

QMemorizing a station

TUNER

(BAND)

TAPE

TUNING

TUNER(BAND)

TUNING

PRESET

OPEN / CLOSE

	PRESET
ON/STAND-BY
DISPLAY MENU	TAPE

DISPLAY CD

TUNER(BAND) TAPE

	AUDIO IN	USB
	X-BASS
TUNING	BASS/TREBLE	VOL
FOLDER		PLAY MODE
	PRESET
	ENTER
CLOCK/TIMER PRESET		MEMORY
DEMO	DIMMER CLEAR	SLEEP
MUTE		MEMORY
		MEMORY

PRESET

You can store 40 AM and FM stations in memory and recall them at the push of a button. (Preset tuning)

1Perform steps 1 - 3 in “Tuning”.

2Press the MEMORY

button to enter the preset tuning saving mode.

3Within 30 seconds, press the PRESET ( or ) button to select the preset channel number. Store the stations in memory, in order, starting with preset channel 1.

4Within 30 seconds, press the MEMORY button to store that station in memory. If the “MEMORY” and preset number indicators disappear before the station is memorized, repeat the operation from step 2.

5Repeat steps 1 - 4 to set other stations, or to change a preset station. When a new station is stored in the memory, the station previously memorized for that preset channel number will be erased.

Note:

The backup function protects the memorized stations for a few hours should there be a power failure or the AC power cord become disconnected.

QTo recall a memorized station

Press the PRESET ( or ) button for less than 0.5 seconds to select the desired station.

QTuning

1Press the ON/STAND-BY button to turn the power on.

2Press the TUNER (BAND) button repeatedly to select the desired frequency band (FM or AM).

3Press the TUNING ( or ) button to tune in to the desired station.

Manual tuning:

Press the TUNING ( or ) button as many times as required to tune in to the desired station.

Auto tuning:

When the TUNING ( or ) button is pressed for more than 0.5 seconds, scanning will start automatically and the tuner will stop at the ﬁrst receivable broadcast station.

Notes:

OWhen radio interference occurs, auto scan tuning may stop automatically at that point.

OAuto scan tuning will skip weak signal stations.

OTo stop the auto tuning, press the TUNING ( or ) button again.

To receive an FM stereo transmission:

OPress the TUNER (BAND) button to display the “ST” indicator.

O“” will appear when an FM broadcast is in stereo.

OIf the FM reception is weak, press the TUNER (BAND) button to extinguish the “ST” indicator. The reception changes to monaural, and the sound becomes clearer.

QTo scan the preset stations

The stations saved in the memory can be scanned automatically. (Preset memory scan)

1Press the PRESET ( or ) button for more than 0.5 seconds. The preset number will ﬂash and the programmed stations will be tuned in sequentially, for 5 seconds each.