Sharp DT-200 operation manual Connecting to a DVD Player and DTV Decoder, Projector

Connecting to Video Equipment

Projector

Setup Connections&

	1
1	S-video cable (commercially available)
	2 To S-video output terminal
	Video cable
	2 To video output terminal

VCR, Laser disc player,

DVD player or DTV decoder

Connecting to a DVD Player and DTV Decoder

Connecting to a DVD player and DTV decorder with Component output (for INPUT 1)

Projector

1Connect each RCA connector of a component cable to the corresponding

RCA INPUT 1 terminals on the projector.

2Connect the other end of the cable to the corresponding terminals on a DVD player or DTV decoder.

CAUTION

•Make sure to turn both the projector and the video equipment off, before switching the “DIGITAL INPUT TYPE” swich and connecting.

2 To component output

terminals
	DVD player
Component cable	or
	DTV decoder
(commercially available)
1

Connecting to a DVD player and DTV decoder with component output (for INPUT 2)

1Connect the 3 RCA to 15-pin D-Sub cable using the DVI to 15-pin D-Sub adaptor.

2 Use the above cables to connect the projector and the DTV decoder.

When connecting this projector to analog RGB output of the DTV decoder, select “Component” for “Signal Type” on the OSD menu or press RGB/COMP. on the remote control. (See page 36.)

CAUTION

•Make sure to turn both the projector and the video equipment off, before switching the “DIGITAL INPUT TYPE” swich and

connecting.Projector

3 RCA to 15-pin D-sub cable (sold separately AN-C3CP)

DVI to 15-pin D-sub adaptor (sold separately AN-A1DV)

E-13

DVD player

or

DTV decoder

DT-200(E)#p12_14.p65 13 02.11.21, 11:30 AM