Introduction, Contents, Operational Notes, English

ENGLISH

INTRODUCTION

Thank you for your purchase of the SHARP electronic calculator, model EL-1801C. Your SHARP calculator is specially designed to save work and increase efficiency in all business applications and general office calculations. Careful reading of this manual will enable you to use your new SHARP calculator to its fullest capability.

CONTENTS
	Page
• OPERATING CONTROLS	1
• INK ROLLER REPLACEMENT	2
• PAPER ROLL REPLACEMENT	3
• BATTERY REPLACEMENT	3
• HOW TO CONNECT THE AC ADAPTOR (OPTION)	4
• ERRORS	4
• SPECIFICATIONS	4
• CALCULATION EXAMPLES	45
• TAX RATE CALCULATIONS	54

OPERATIONAL NOTES

To insure trouble-free operation of your SHARP calculator, we recommend the following:

1.The calculator should be kept in areas free from extreme temperature changes, moisture, and dust.

2.A soft, dry cloth should be used to clean the calculator. Do not use solvents or a wet cloth.

3.Since this product is not waterproof, do not use it or store it where fluids, for example water, can splash onto it. Raindrops, water spray, juice, coffee, steam, perspiration, etc. will also cause malfunction.

4.If service should be required, use only a SHARP servicing dealer, a SHARP approved service facility or SHARP repair service.

5.If you pull out the power cord to cut electricity completely or replace the batteries, the presently stored tax rate will be cleared.

SHARP will not be liable nor responsible for any incidental or consequential economic or property damage caused by misuse and/or malfunctions of this product and its peripherals, unless such liability is acknowledged by law.

– 1 –

OPERATING CONTROLS

OFF • P•IC ON POWER SWITCH; PRINT / ITEM COUNT MODE SELECTOR:

“OFF”:	Power OFF
“•”:	Power ON. Set to the non-print mode.
“P•IC”:	Power ON. Set to the print and item count mode.
	For addition or subtraction, each time + is pressed, 1 is added
	to the item counter, and each time – is pressed, 1 is subtracted.

•The count is printed when the calculated result is obtained.

• Pressing of			, C CE C CE clears the counter.

Note: The counter has a maximum capacity of 3 digits (up to ±999). If the count exceeds the maximum, the counter will recount from zero.

F 2 0 A

DECIMAL / ADD MODE SELECTOR:

“F”: The answer is displayed in the floating decimal system.

“2,0”: Presets the number of decimal places in the answer.

“A”: The decimal point in addition and subtraction entries is automatically positioned to the 2nd digit from the lowest digit of entry number. Use of the add mode permits addition and subtraction of numbers without

entry of the decimal point. Use of , and will automatically override the add mode and decimally correct answers will be printed.