Sharp FU-W28E operation manual Plasmacluster ON/OFF Button, LIGHTS ON/OFF Button

Fan Speed Button

Plasmacluster ON/OFF Button

POWER ON/OFF Button

CLEAN - SIGN Light

The colour changes according to the air condition.

Clean	Slightly Impure		Very Impure
Green		Orange		Red

ABOUT THE CLEAN-SIGN

•The condition of the CLEAN-SIGN depends on the room air condition detected by the Odour Sensor when the plug is inserted into the wall outlet.

•It is possible to have a green CLEAN SIGN if there are impurities in the are when the product is first turned on. After a while, however, the base impurit rate will be adjusted to detect room air condition correctly.

Plasmacluster ON/OFF Button

Press the Plasmacluster ON/OFF Button to turn Plasmacluster Ion Mode ON and OFF.

When Plasmacluster is ON, both the Indicator Light and Plas- macluster Indicator Light will turn on.(blue)

LIGHTS ON/OFF Button

(Please press the Plasmacluster ON/OFF Button for 3 seconds.)

Switches the Plasmacluster Indicator Light and CLEAN-SIGN

Light either ON or OFF.

ADJUSTMENT OF SENSOR DETECTION SENSITIVITY

Set to “low” if CLEAN-SIGN Light constantly red to reduce sensitivity, and set to “high” if CLEAN-SIGN Light is constantly green to increase sensitivity.

1 With the unit OFF, press the Fan Speed Button for 3 seconds.

The Fan Speed Indicator Lights will display the currently set sensor sensitivity level. The factory setting is Standard, indicated by the MED light.

ENGLISH

2 Press the Fan Speed Button to set the desired sensor sensitivity.

Refer to the diagram on the right to select the desired sensor sensitivity level.

3 Press the Power ON/OFF Button. Note that if the Power ON/OFF Button is not pushed within 8 seconds of adjusting sen- sor sensitivity, the setting will be saved auto- matically. The sensor sensitivity setting will be saved even if the unit is unplugged.

Fan Speed	Sensor Detection
Indicator Light	sensitivity
	High
	Standard
	Low

E-9