ENGLISH
Speaker preparation (continued)
Preparation for Use
To mount the speaker on the wall
Caution:
zBe very careful to prevent the speaker [1.75 kg (3.86 lbs.)] from falling when mounting on the wall.
zBefore mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The speaker may fall.) If unsure, consult a qualified service technician.
zMounting screws are not supplied. Use appropriate ones.
zCheck all wall mount angle screws for looseness.
zSelect a good location. If not, accidents may occur or the speaker may get damaged.
zSHARP is not responsible for accidents resulting from improper installation.
Driving screws
SHARP designed the speakers so you may hang them on the wall. Use proper screws (not supplied). See below for size and type.
| 3.2 mm (1/8") |
5 mm |
|
(3/16") | 9 mm (3/8" ) |
| Min. 22 mm (7/8" ) |
Wall mount angle fixed to the wall (Horizontal position)
1Fix the pattern paper to the wall in horizontal position as below.
509 mm | 44 mm | |
29 mm | ||
Wall surface 44 mm |
29 mm | Pattern paper |
|
2Make a hole on the wall following the screw point marks on the pattern paper by using a drill.
32 mm
Wall surface
3Fix a wall mount plug into the hole using a hammer, until it is flush with the wall surface.
32 mm
Wall surface
2008 December 17 |