Sharp HT-SL70, HT-SL75 General Control, E-10, To turn the power on, Volume, Power Off

General Control

Make sure to enable the HDMI CEC when making HDMI connection. For details, refer to the operation manual of the TV.

■To turn the power on

Plug the AC power lead into a wall socket, the stand-by indicator turns RED.

This unit will automatically power on if:

1.TV or similar component which supports HDMI CEC, is turned on.

2.Audio signal is detected from Audio input.

The stand-by indicator will turn BLUE if TV signal is detected.

Notes:

●HDMI input will override the Audio input signal.

●Audio input will function only when there is no signal from HDMI input.

●A slight audio delay after TV is turned ON does not mean that the system is faulty. This is normal.

●“AQUOS speaker is enabled” message will be displayed if SHARP LCD TV does not detect HT-SL70/ HT-SL75 during power on. However the message “AQUOS audio with AQUOS LINK is enabled” will be displayed soon as HT-SL70/HT-SL75 is detected. These messages may vary for other TV model.

■Audio Return Channel (ARC) (Audio Return Channel submenu)

The Audio Return Channel (ARC) enables an HDMI ARC- capable TV to send the audio stream to the HDMI OUT terminal of the receiver. To use this function, your TV must support the ARC. Make sure the LCD TV Audio output setting is set to PCM, not other formats such as Dolby Digital, DTS, etc. For details, refer to the operation manual of the TV.

■Volume

Volume can only be controlled from your TV.

■Power Off

This unit will automatically go to stand-by mode (indicator turns RED) if:

1.TV or similar component which supports HDMI CEC, is turned off.

2.No signal from Audio input is detected after 20 minutes.

E-10