General control (continued)
■Function
On the unit:
When the FUNCTION but- ton is pressed, the input
source will change. Press it repeatedly to select desired input source.
On remote control:
Press the LINE button repeat-
edly to select “L1” (LINE IN 1 input) or “L2” (LINE IN
2 input).
Press the DIGITAL 1 button to select „d1” or DIGITAL 2 button to select „d2”.
Note:
The backup function will protect the memorized function mode for a few hours should there be a power failure or the AC power cord becomes disconnected.
Auto power on function:
When you press the LINE / DIGITAL 1 / DIGITAL 2 button on the remote control, the unit will turn on at the selected function.
Auto power off and auto detect signal:
●The unit will automatically go to
1.No signal is detected within 20 minutes.
2.“d1” or “d2” display is blinking for 20 minutes during power on.
●The unit will automatically power ON if it de- tects audio signal from connected equipment, unless it is turned off manually.
Troubleshooting chart
Many potential problems can be resolved by the owner without calling a service technician.
If something is wrong with this product, check the following before calling your authorised SHARP dealer or service center.
■ General
Symptom | Possible cause |
No sound is heard. | ● Is the input signal |
| (selection) set |
| properly? |
| ● Is the volume level set |
| to “0”? |
| ● Is muting activated? |
Noise is heard | ● Move the unit away |
during playback. | from any computers |
| or mobile phones. |
|
|
When a button is | ● Set this unit to the |
pressed, the unit | |
does not respond. | then turn it back on. |
|
|
The power is not | ● Is the unit unplugged? |
turned on. | (Refer to page 10) |
| ● The protection circuit |
| may be activated. |
| Unplug and plug in |
| the power cord again |
| after 5 minutes or |
| more. |
|
|
The information | ● Is the unit set to |
is not displayed | “Dimmer display off” |
even if the unit is | mode? |
turned on. |
|
■Remote control
Symptom | Possible cause |
The remote control | ● Is the battery polarity |
does not operate | correct? |
properly. | ● Is the battery dead? |
| ● Is the distance or |
| angle incorrect? |
| ● Are there any |
| obstructions in front of |
| the unit? |
| ● Is there a strong light |
| shining on the remote |
| sensor? |
| ● Is the remote control |
| for another equipment |
| used simultaneously? |