Sharp HTSB350 System preparation continued, Driving screws, Installing the sound bar

System preparation (continued)

■Driving screws

SHARP designed the speakers so you may hang them on the wall. Use proper screws (not sup- plied). See below for size and type.

1/8” (3.2 mm)

3/16”
(5 mm)	3/8” (9 mm)
	Min. 7/8” (22 mm)

■Wall mount angle fixed to the wall (Horizontal position)

Fix the pattern paper to the wall in horizontal position as below.

	44 mm
509 mm
Wall surface 44 mm	29 mm
29 mm	Pattern paper

Make a hole on the wall following the screw point marks on the pattern paper by using a drill.

1-1/4” (32 mm)

3/8” (8-9 mm)

Wall surface

3Fix a wall mount plug into the hole using a hammer, until it is flush with the wall surface.

1-1/4” (32 mm)

3/8” (8-9 mm)

Wall surface

Screw the wall mount angle to the wall as shown in the illustration. (Total screw is 8 pieces)

Wall mount angle

Wall surface

Wall mount angle (screws x 4)

(screws x 4)

Wall surface

Wall mount angle

Wall surface

Note:

Make sure all screws are fully tightened. (screws are not supplied)

■Installing the sound bar

Align the wall mount slot at the unit to the wall mount angle.

Slot the unit into the wall mount angle.

3Fix them securely.

Wall surface

E-