Sharp KC-850U operation manual 2Rinse the Humidifying Tray with lukewarm water

Insert the tab of the float into the hole.

HUMIDIFYING TRAY

		Frequency of maintenance cycle will depend on the hardness
Care Cycle	1 month
		of the water. Avoid spilling water when removing or cleaning
		the tray.

1	Remove the Water Tank and Humidifying Tray.
	Unlatch the Water
	Tank first, then re-	Tank Handle
	move the tray. Use
	both hands when
	pulling out the
	Humidifying Tray to	Water Tank
	avoid spilling water.

2Remove the Water Tank and Humidifying filter from the Humidifying Tray. Drain ac- cumulated water by tilting the Humidify- ing Tray slowly.

Do not hold this part.

Humidifying filter	Humidifying
	Tray

3Rinse the inside of the Humidifying Tray with lukewarm water to remove impurities.

• Do not remove the Float Styrofoam float .

• Clean difficult-to- reach parts with a cotton-tipped swab or tooth brush.

4Replace the Humidifying filter and re- place the Humidifying Tray in the unit.

The Humidifying filter will not	Color:Gray
fit if placed in backwards. Be
sure there is no gap between
the Humidifying tray and the
unit when the Humidifying Tray
is replaced in the unit. The unit
may not operate properly if the
Humidifying Tray is not prop-
erly replaced in the unit.
If the Styrofoam float comes off,
replace by inserting the tabs of
the Float into the holes in the
Humidifying Tray as shown in the
diagram.

When Water Deposits are Difficult to Remove

1Fill Humidifying Tray halfway with lukewarm water, add a small amount of mild kitchen detergent, and leave to soak for about 30 minutes.

Dilute detergent according to instructions on the container. Clean difficult-to-reach parts with a cotton swab or tooth brush.

2Rinse the Humidifying Tray with lukewarm water.

•Rinse until all detergent residue is removed.

•Inadequate rinsing may cause the detergent odor or changes

in the shape/ color of the main unit.

CAUTION

•Use only mild kitchen detergents to clean the Humidifying Tray. Use of non-designated chemicals or deter- gents can cause deformation, tarnish- ing, cracking (water leakage).

Insert the float below this tab.

Insert the tab on the other side of the float into the hole.

ENGLISH

E-17