On-Screen Display Menu

Setup Menu

Example

Setup

EZ Setup

Input Skip

Position

Language[English]

Identification

Reset

1

Press MENU to display the MENU screen, and

2

then press

/

to select “Setup”.

Press

/

to select a specific adjustment

3

item, and then press ENTER.

Press

/

(or

/ ) to select the desired

4

setting, and then press ENTER.

Press MENU to exit.

EZ Setup

This function allows you to change the preset values.

Language: Select from among 4 languages (English, French, Spanish and German).

Monitor Location: Select “Home” or “Store” for the location where you plan to install the LCD Monitor.

•• If you select “Home”, AV MODE is set to “STANDARD”.

•• If you select “Store”, AV MODE is set to “DYNAMIC (Fixed)”.

•• See “Initial Setup” on page 17 for setting each item.

Input Skip

This setting allows you to skip the HDMI or PC-IN Input (“Input 4”, “Input 5”, “Input 6” and “Input 7”) on the Input Selection operation.

Yes: Skips the input.

No: Does not skip input.

Input Label

Lets you set the input terminal displayed when using the INPUT SOURCE menu. Press

/ / / to select the new name for the input mode.

Input Signal(for Analog PC Input Mode Only)

Some input signals may have to be registered manually to display properly. The pair of input signals (resolutions) in the list below is not distinguishable when received. In such a case, you have to set the correct signal manually. After setting once, it will display when the same signal (resolution) is input again.

1024 x 768

1360 x 768

•• You can only select the “Input Signal” on the Setup menu when receiving one of the 2 input signals listed above.

Auto Sync. Adjustment

(for Analog PC Input Mode Only)

For automatically adjusting the PC image.

Yes: Auto Sync. starts and “Now adjusting the image.” displays.

No: This function does not work.

•• When Auto Sync. is successful, “Completed” displays. If not, Auto Sync. failed.

•• Auto Sync. may fail even if “Completed” displays.

•• Auto Sync. may fail if the computer image has low resolution, has unclear (black) edges, or is moved while executing Auto Sync.

•• Be sure to connect the PC to the LCD Monitor and switch it on before starting Auto Sync.

Fine Sync. Adjustment

Ordinarily you can easily adjust the picture as necessary to change image position using Auto Sync. In some cases, however, manual adjustment is needed to optimize the image.

H-Pos.:Centers the image by moving it to the left or right.

V-Pos.:Centers the image by moving it up or down.

Clock: Adjust when the image flickers with vertical

stripes.

Phase: Adjust when characters have low contrast or when the image flickers.

•• For resetting all Fine Sync. adjustment items to the factory preset values, press / to select “Reset”, and then press ENTER.

•• It is not necessary to adjust the “Clock” or “Phase” when a digital signal is being input, so it cannot be selected.

•• The default cursor position may not be in the center, because the screen position variable ranges may be asymmetrical.

•• The screen position variable ranges depend on the View Mode or the signal type.

26