Sharp LC-26D40U Other viewing options, Freezing images Presetting remote control function

SIGNAL METER

Other viewing options

Freezing images Presetting remote control function

Allows you to capture and freeze an image from a moving image that you are watching.

You can operate the connected AV products (AV Receiver, Cable Box, SAT tuner, DTV, VCR, DVD, LD) using the presetting manufacturer function of your remote control unit.

1	Press FREEZE.
	• A moving image is captured.
2	Press FREEZE again to cancel the
	function.

NOTE

•When this function is not available, “NOT AVAILABLE” will display.

•The still image automatically goes out after 30 minutes.

•If you are using the freeze function and a broadcast activates the V-CHIP block, the freeze function will be cancelled and a V-CHIP block message will appear.

Signal meter

In order to receive digital air broadcasts, you need a digital broadcast antenna. You can confirm the antenna configuration through the “SIGNAL METER” menu.

If necessary, adjust the direction of the antenna to obtain the maximum signal strength.

Signal strength
1	Press MENU and the MENU screen
	displays.
2	Press	/ to select	(SETUP).
	Press	/ to select “SIGNAL METER”.
3
4	Press	/ .

•The strength of the digital signal is displayed. The signal information is based on the current channel.

CHANNEL (DIGITAL) 23.002

40

5 Press EXIT to return to the normal screen.

Presetting manufacturer codes

1	Press FUNCTION until the LED for your
	device lights up.
2	After the LED for your device lights up,
	press FUNCTION and DISPLAY at the
	same time to enter the code registration
	mode. The LED will blink.
3	Press 0–9to enter the manufacturer code.
	(See page 36.)
	• Preset mode is finished once the LED no
	longer lights up.
4	After registering the code, the LED will stop
	blinking then turn off after one second. (If

you perform an incorrect operation, the LED will blink quickly then turn off.)

35

3Y10101A.indb 35

2006/01/19 20:30:40