Quick guide
Attaching the stand
Before performing work spread cushioning over the base area to lay the TV on, making sure the area is completely flat. This will prevent it from being damaged.
Before attaching (or detaching) stand, unplug the AC cord from the AC INPUT terminal.
1 Confirm the 8 screws supplied with the TV.
Short screws (m4) | Long screws (m4) |
2 Attach the two parts of the stand unit to each other using the 4 short screws as shown.
(used in step 2) | (used in step 4) |
3 Insert the stand into the opening on the bottom of the TV.
4 Insert and tighten the 4 long screws on the rear of the TV as shown.
NOTE
• To detach the stand, perform the above steps in reverse order.
Setting the TV
For
Ferrite Core
The Ferrite Core should be permanently attached and never removed from the AC cord.
Ferrite Core
Standard DIN45325 plug (IEC
Cable tie 
Cable clamp
Place the TV close to the AC outlet, and keep the power plug within reach.
Product shape varies in some countries.
AC cord
Setting the TV on the wall
•This TV should be mounted on the wall only with the wall mount bracket available from SHARP. (See page 23.) The use of other wall mount brackets may result in an unstable installation and may cause serious injuries.
•Installing the LCD Colour TV requires special skill that should only be performed by qualified service personnel.
Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting |
|
or mounting that results in accident or injury. | 3 |
• You can ask a qualified service personnel about using an optional bracket to mount the TV to the wall. |
