Do not plug out the USB/HDD during the recording. This may harm the connected USB/HDD.

Only two partitions on a HDD unit can be supported.

Some stream packets may not be recorded because of signal problems, so sometimes video may freezes during playback.

Record, Play, Pause, Display (for PlayListDialog) keys could not be used when teletext is ON. If a recording starts from timer when teletext is ON, teletext is automatically turned off. Also teletext usage is disabled when there is ongoing recording or playback.

If the recording time of an event is longer than the memory capacity, the following message will appear on the screen: “There is not enough space for ‘event’ but it will be recorded until the drive is full”.

Connecting the LED TV to a PC

For displaying your computer’s screen image on your LED TV, you can connect your computer to the TV set. Power off both computer and display before making any connections. Use 15-pin D-sub display cable to connect a PC to the LED TV. When the connection is made, switch to PC source. See “Input selection” section. Set the resolution that suits your viewing requirements. Resolution information can be found in the appendix parts.

Audio inputs of the TV

PC input of the TV

 

PC audio cable

PC VGA cable

(not supplied)

(not supplied)

Audio output of the PC

Monitor output of the PC

 

Connecting to a DVD Player

If you want to connect a DVD player to your LED TV, you can use connectors of the TV set. DVD players may have different connectors. Please refer to your DVD player’s instruction book for additional information. Power off both the TV and the device before making any connections.

Note: Cables shown in the illustration are not supplied.

If your DVD player has an HDMI socket, you can connect via HDMI. When you connect to DVD player as illustrated below, switch to HDMI source. See, “Input Selection” section.

Most DVD players are connected through COMPONENT SOCKETS. Use a component video cable to connect video input. For enabling audio, use a component audio cable as illustrated below. When the connection is made, switch to YPbPr source. See, “Input selection” section.

You may also connect through the SCART 1 or SCART 2. Use a SCART cable as shown below.

Note: These three methods of connection perform the same function but in different levels of quality. It is not necessary to connect by all three methods.

HDMI

 

Component

Component

 

Scart sockets

video

audio

HDMI

inputs

inputs

 

inputs

 

 

 

DVD Player

English - 12 -

A01_MB61_[GB]_1910UK_IDTV_TC_PVR_BRONZE16_40942LED_100Hz

_

ROCKER_10073199_50190031.indd 12

09.08.2011 08:35:39

 

 

 

 

Page 13
Image 13
Sharp LC-40LE530E operation manual Connecting to a DVD Player, Connecting the LED TV to a PC