Sharp Preparation

5
Attaching the stand unit
• Before performing work, spread cushioning over the
surface on which you will be laying the TV. This will
prevent it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect
installation of the stand may result in the TV falling
over.
1Confirm that there are screws with the stand
unit.
1For 60 inch models
(four long screws, five middle screws and two
short screws)
2For 52 inch models
(four long screws, four middle screws and one
short screw)
2Attach the supporting post for the stand unit
onto the base using the long screws with a
screwdriver as shown.
Supporting
post
60 inch models 52 inch models
3Insert the stand into the openings on the bottom
of the TV (hold the stand so it will not drop from
the edge of the base area).
• Make sure that the stand is firmly inserted into the
TV. Improper installation may result in tilting of the
TV set.
Soft cushion
60 inch models 52 inch models
4Insert and tighten middle screws into the holes
on the rear of the TV.
60 inch models 52 inch models
5Attaching the stand cover.
1Insert the stand cover.
2Insert and tighten the short screw(s) into the
hole(s) of the stand cover.
60 inch models 52 inch models
NOTE
• To detach the stand unit, perform the steps in reverse
order.
• A screwdriver is not supplied with this product.
• The TV can be rotated up to 20 degrees to the right and
left.
Preparation