Sharp LC 20S4U Sound Volume, Changing Channels, ■Using FLASHBACK, ■To mute the sound, ■To adjust the volume, ■Using Channel Select, Basic Operation (Continued)

Basic Operation (Continued)

Sound Volume Changing Channels

■To adjust the volume

●Press VOL (+) to increase the sound volume. The bar indicator shifts right.

VOLUME 50

●Press VOL (–)to decrease the sound volume. The bar indicator shifts left.

VOLUME 10

■To mute the sound

●Press MUTE to temporarily turn off the sound.

The MUTE mark is displayed for 4 seconds.

●Press MUTE or VOL (+)/(–)to turn the sound back to the previous level.

The mute function is automatically turned off when any of the following buttons are pressed: POWER, MUTE, VOL (+)/(–)or MTS.

VOLUME 10

A

•When VOL (+)/(–)is pressed in the Mute mode, the sound turns on and the volume indicator is displayed.

•The Mute function is canceled when POWER is pressed.

■To select MTS (Multichannel TV Sound)

1	Press MTS to display the MTS screen.
2	Press MTS to select the MTS settings.

STEREO: stereo audio

SAP: secondary audio program

MONO: monophonic audio

STEREO <ON A I R

SAP <ON A I R

MONO

A

•“ON AIR” appears when a STEREO or SAP broadcast is being aired.

You can select channels using Channel Select or

CH ( )/( ).

•This LCD TV set allows you to select up to 125 channels

(1 to 125). To select a channel, enter a 2- or 3-digit number.

■Using Channel Select

When selecting the channel using Channel Select, complete input of the channel number by holding down the button for the last digit for a moment.

To select a 1- or 2-digit channel number (e.g., Channel 5):

Complete the following procedure within 4 seconds.

1	Press the	button.	2	Press the	button.
		0 –
					5

A

•When selecting a 1-digit channel number, do not fail to press the button first.

To select a 3-digit channel number (e.g., Channel 115):

Complete the following procedure within 4 seconds.

1	Press the	button.	2	Press the	button.
		1 – –			1 1 –

3 Press the button.

1 1 5

A

•The 3-digit channel number can be selected only when the receiving mode is set to CABLE in CH-SETTING. (For details on setting the receiving mode, see page 24.)

Changing channels with CH ( )/( ) on the remote control

Air: Press CH (	) and the channels change in the order shown below:
2 → 3 → . . . → 68 → 69 → 2 → 3 → . . .
Press CH (	) and the channels change in the order shown below:
3 → 2 → 69 → 68 → . . . → 3 → 2 → . . .
Cable: Press CH (	) and the channels change in the order shown below:
1 → 2 → 3 → . . . → 125 →1 → 2 → 3 → . . .
Press CH (	) and the channels change in the order shown below:

3 → 2 → 1 → 125 → . . . → 3 → 2 → 1 → . . .

■Using FLASHBACK

●Press FLASHBACK to switch the currently tuned channel to the previously tuned channel.

●Press FLASHBACK again to switch back to the currently tuned channel.

18