Sharp LC 37HV6U operation manual Outdoor antenna connection, Connecting Antenna Cable with VCR

Watching TV

C.Connecting Antenna Cable with VCR

RF Cable (Supplied)

Coaxial Antenna Cable (commercially available)

Rear Terminals	2-way
	signal
	splitter
	(not
	supplied) Cable lead-in
	Coaxial Antenna Cable
	(commercially available)

VCR

S-VIDEO VIDEO AUDIO OUT IN

Video Cable (commercially available)

Audio Cable (commercially available)

S-video Cable (commercially available)

NOTE

•Be sure to remember what kind of connection is made with your System.

•Shown here is the preferred method of connecting a VCR to your TV if you are in an area with good signal reception. This way you can view either TV programs or VCR tapes and not be concerned about the position of the VCR’s TV/VCR switch and you can enjoy stereo tape playback from stereo VCR.

•If your VCR has an S-Video terminal, S-video connection is recommended.

•If your lead cable is a 300-ohm twin-lead cable or UHF/VHF separate cable, use a 300/75-ohm adapter or combiner (output side is 75-ohm coaxial) to connect to the TV (see below).

Outdoor antenna connection

Connecting Antenna Cable

Cable without a CATV Cable TV lead-In converter

Combination
VHF/UHF antenna
or	75-ohm coaxial cable (round)
	300/75-ohm adapter
	(commercially available)
	300-ohm twin-lead (flat)
VHF	UHF
ANTENNA ANTENNA
Separate VHF/UHF	300-ohm	Combiner
antenna	twin-lead
		(commercially
	300-ohm twin-lead	available)
		IN OUT
or	75-ohm coaxial cable

Home Antenna terminal (75-ohm)

Coaxial cable	RF Cable (Supplied)
(commercially
available)

NOTICE

F-type connector should be finger-tightened only.

F-type connector

When connecting the RF cable to the TV set, do not tighten F-type connector with tools.

If tools are used, it may cause damage to your TV set. (The breaking of internal circuit, etc.)

75-ohm coaxial cable

19