Sharp LL-P202V, LL-S242A-W Disassembling the rack stand

Portrait orientation

Run the cables along the hollow on the front side and out

between the legs of the back side.

7. Secure the monitor to the stand using the two xing

screws.

Landscape orientation

Fixing screws (supplied)

Portrait orientation

Fixing screws (supplied)

Disassembling the rack stand

Remove the monitor from the rack stand before disassembling

the stand.

Caution

• After removing the monitor from the rack stand, store the

screws safely so that they cannot become lost.

1. Remove the screws and remove the monitor.

Remove fixing screws

2. Disengage the tabs of the support on the front side,

and raise the support.

3. Fold the stand closed so that the sides are parallel and

separate the front and back sides.

Installation

Contents

Main Information on the Disposal of this Equipment IMPORTANT INFORMATION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION SAFETY PRECAUTIONS DEAR SHARP CUSTOMER SAFETY PRECAUTIONS (Continued) TIPS AND SAFETY INSTRUCTIONS The Power Cord and AC Adapter Manual Scope LED Backlight Supplied Components Contents System Requirements nTouch panel nFront view LL-P202V LL-S242A-W Part Names nRear view LL-P202V LL-S242A-W Binding Cables Video cable and USB cable Applying the Logo Sticker Connecting Devices Binding Cables Connection with a PC nInputting video and audio Digitizer pen cable Connecting USB devices Connecting the digitizer pen (LL-P202V) Connecting the Monitor to a Power Source Installation Installing on a stand (Standing position) nLL-P202V Placement on the variable stand nLL-S242A-W Placement on the rack stand Disassembling the rack stand Installing on a table (Pen writing position/Horizontal position) nLL-P202V Pen writing position Horizontal position nLL-S242A-W Turning Power On/Off Turning off the power Installing the Software Installation Touch Actions Touch action modes Touch action nActions common to ngers, digitizer pens, and touch pens nFinger actions Digitizer pen nDigitizer pen actions nDigitizer pen stand nSpare pen tip storage nReplacing the digitizer pen tip Other functions Cautionary points Monitor Settings Menu operations nExample of operation Menu functions Exit Setup Input Select Volume Finger-only Touch mode selection Pen-only Finger/pen SETUP Menu Details This setting congures whether or not to display the logo screen during startup. Prohibiting operations (operation lock) n Locking operation n Disabling operation lock Monitor status indicators Troubleshooting Specications nProduct Specications nDimensional Drawings Notethatthevaluesshownareapproximatevalues. LL-S242A-W * Heightofbottomofscreenfromtablesurface Unit: inch [mm] LL-P202V nPen writing position (LL-P202V) nSupported frequency nDDC (plug and play) nHDMI input terminal pins (HDMITM Connector) nDisplayPort input terminal pins (DisplayPort 20 pin)