<P=004>
SETTING THE CLOCK
1Press the ON/STAND-BY button to turn the power on.
2Press the CLOCK button.
3Within 5 seconds, press the ENTER button.
4Turn the jog dial to select the time display mode.
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
"12:00 AM" The 12-hour display will appear.
(AM or PM 12:00 - 11:59)
"0:00 AM" The 12-hour display will appear.
(AM or PM 0:00 - 11:59)
Note that this can only be set when the unit is first installed
or it has been reset (see page 53).
5Press the ENTER button.
6Adjust the hour by turning the jog dial.
When the jog dial is turned one click clockwise, the time will
increase by 1 hour. When it is turned one click anti-clockwise,
the time will decrease by 1 hour.
Keep turning the jog dial to change the time continuously.
When the 12-hour display is selected, "AM" will change auto-
matically to "PM".
7Press the ENTER button.
8Adjust the minutes by turning the jog dial.
When the jog dial is turned one click clockwise, the time will
increase by 1 minute. When it is turned one click anti-clockwise,
the time will decrease by 1 minute.
Keep turning the jog dial to change the time continuously.
The hour setting will not advance even if minutes advance from
"59" to "00".
9Press the ENTER button.
The clock starts operating from "0" seconds.
(Seconds are not displayed.)
Note:
In the event of a power failure or when the AC power lead is
disconnected, the clock setting will be lost. Reset the time.
12:00 AM 0:00 AM0:00
2
3
4
7
6
5
8
9
To change the clock time:
Press the CLOCK button.
Within 5 seconds, press the ENTER button.
Perform steps 6 - 9 above.
To see the time display:
Press the CLOCK button.
The time display will appear for about 5 seconds.
To change the time display mode:
Perform steps 1 - 2 in the section "If a problem occurs", on
page 53.
Perform steps 1 - 9 above.
In this example, the clock is set for the
24-hour (0:00) system.
Jog dial
CLOCK
ON/
STAND-BY
ENTER
MD-C2H(SUK) TINSE0238AWZZ
9