Important Safety Instructions
IMPORTANT:
Your KODAK EKTAGRAPHIC III AFT Projector is supplied with a
We urge you to provide a permanent, properly installed
125 volts will adversely affect lamp life.
When using your projector, always follow these basic safety precautions:
1.Read and understand all instructions before using this equipment.
2.Operate this projector with
3.Close supervision is necessary when any appliance is used by or near children, or others who may not understand the need for these precautions. Do not leave the projector unattended during use.
4.Be careful not to touch hot parts. For lamp replacement, allow the module to cool before touching the lamp and the surrounding area. Do not place the lamp module on
5.Do not operate your projector if the power cord is damaged or if the projector has been dropped or damaged.
6.Position the cord so that it is not tripped over. pulled, or placed in contact with hot surfaces.
7.If an extension cord is necessary, use a cord with a current rating at least equal to that of the projector. Cords rated for less amperage than the projector may overheat.
8.Always unplug the projector from the electrical outlet before cleaning and servicing and when not in use.
9.Allow the projector to cool before storing.
10.Do not immerse this equipment in water or other liquids.
11.Do not disassemble this projector. Use a qualified service technician when service or repair is required. Incorrect reassemble can cause electric shock the next time the projector is used.
12.Use only safety electrical
13.The use of an accessory attachment not recommended by the manufacturer may increase the risk of damage.
14.Keep the airflow vents unobstructed.
