
KODAK EKTAGRAPHIC III AFT Projector
Maintenance
Maintenance is recommend at least every 1200 hours of operation. Dirt and dust can have an adverse effect on lubricants used in the projector and may cause malfunctions. Projectors that are operated in dusty environments should have maintenance more frequently.
Recommended cleaning materials:
· Lens cleaner | · Clean, soft cloth |
· Glass cleaner (no solvent based cleaners) | · Lens tissues |
· Soft bristle brushes | · Can of compressed air |
· Cotton swabs |
|
How to clean your projector
Follow these maintenance instructions for safe, efficient cleaning of your projector. Be sure your projector is unplugged and cool before performing any maintenance on it.
1.Clean the projector housing with a clean, soft cloth and glass cleaner.
2.Inspect the gate for cleanliness. If the gate area is dirty use a brush and compressed air to clean it.
3.If the gate rails are dirty or have a white powder coating, slides may not fall properly. Spray a cotton swab with glass cleaner and gently scrub the rails to remove the powder buildup. Use a dry cotton swab to remove excess cleaner.
CAUTION: When cleaning gate rails do not bend the pressure pad.
4.Loss of illumination can be caused by a dirty mirror, condenser lens, or projection lens. Remove the lamp module. Clean the mirror using lens cleaner or clear water, and a soft
5.Clean the condenser lens with lens cleaner or water and a
6.Clean the projection lens with lens cleaner or clear water. Do not clean the lens with a dry cloth.
7.Keep the air exhaust grille clean. Use compressed air and a brush to remove dirt. Inspect this area often! If it appears dirty, your projector may require professional cleaning* and should be taken to an Authorized Kodak Repair Shop.
*Cleaning is not covered under the Manufacturer’s Warranty.
Step 2 | Step 3 | Step 4 |
Step 5 | Step 6 | Step 7 |