
Operation
The KODAK EKTAGRAPHIC III AFT Projector is equipped with controls to adjust the FADE and VIEW cycles. They are located under the projector handle. It is shipped with factory default settings of:
·AUTOMATIC AFT mode - ON ( I )
·VIEW time - 10 seconds
·FADE Up and Down - 0.5 second each (total 1 second)
To use:
1.Install a loaded slide tray.
2.Turn the slide projector ON by selecting low or high lamp position on the control panel.
3.The projector will automatically advance slides, fading between slide changes, and will continue until the projector is turned off.
To adjust VIEW control:
Using a small,
To adjust FADE control:
Using a small,
NOTE: You may make these adjustments with the projector lamp either ON or OFF.
To turn off AFT mode:
Using a
Tips
·Keep the operating environment clean; dust and dirt can negatively impact operation.
·To help maximize projector performance, clean the projector regularly following the maintenance instructions included here.
·Keep extra lamps on hand.
·Have an extra lamp module on hand for quick lamp change. It only takes a few seconds to change a lamp module, but it could take a while for a lamp to cool enough to change the lamp itself!
·For cooler operating temperature and longer lamp life, use an FHS lamp designed for use with KODAK EKTAGRAPHIC Slide Projectors. If you wish to purchase this lamp, ask your local dealer to order CAT No. 147 7678.
·Note your local dealer and service organization telephone numbers here for quick reference. Local Kodak Dealer: _____________________________________________________________
_____________________________________________________________________________
|
|
|
| New 2/98. Minor revision 7/99 |
|
|
|
| |
Part No. 2H2412 | Kodak and Ektagraphic are trademarks. | Printed in U.S.A. | ||
| www.kodak.com/go/projectors |
|