OPERATION OF TOUCH CONTROL PANEL
The operation of the oven is controlled by pressing the appropriate pads arranged on the surface of the control panel.
An entry signal tone should be heard each time you press the control panel to make a correct entry.
Before Operating
•When you first connect the microwave oven to an
electrical socket, the digital display will show
.
•Key pad entries can only be made when the door is shut.
Sound Setting
•There is a choice of 2 different sounds and no sound on your oven.
•The programme or check mode is cancelled when any pads are not pressed for more than 3 min- utes.
•
will appear on the display after the time reaches zero. It will disappear when the oven door is opened or the STOP/CLEAR pad is pressed.
•To set signal, touch the SET pad twice within 2 seconds and then touch the SIGNAL pad continu- ously until you hear desired tone.
Stop/Clear
•If you want to stop the oven during cooking:
1.Press the STOP/CLEAR pad once.
2.Open the door (except memory cooking).
To start the oven again, close the door and press the START pad within 1 minute.
MEMORY OPERATION
•This oven has 20 memory banks
•The memory banks
•In addition for all memory banks a time constant 1.7 for the double quantity is stored. The stored time constant can also be changed individually if required.
•Information in these memory banks is not lost due to power interruptions. If the power goes off, the oven does not need to be reprogrammed. No bat- teries are necessary for this type of memory.
•If you want to cook using memory
•If you open the door during memory cooking, the programme is cancelled.
•If you want to cancel a programme during cook- ing, press the STOP/CLEAR pad twice.
•If you want to clear a mistake during program- ming, press the STOP/CLEAR pad once.
Memory No. | Cook Time | Output Power |
1 | 10 sec. | 100% |
2 | 20 sec. | 100% |
3 | 30 sec. | 100% |
4 | 45 sec. | 100% |
5 | 1 min. | 100% |
6 | 1 min. 15 sec. | 100% |
7 | 1 min. 30 sec. | 100% |
8 | 2 min. | 100% |
9 | 2 min. 30 sec. | 100% |
0 | 3 min. | 100% |
To check the stored programmes please refer to "Memory check" on page 9.
To change the stored programmes please refer to "Memory programme entry" on page 6.
Cooking with Memory
* Suppose you want to cook by using memory 1, which was programmed for 10 seconds at 100%.
Step | Procedure |
| Pad Order |
| Display | |
1 | Press the NUMBER pad | . |
|
|
|
|
|
|
|
| |||
|
|
|
|
| NO. |
|
|
|
|
|
|
|
|
|
|
|
| After about 1 sec. | ||
|
|
|
|
|
| |
|
|
|
|
| ON |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
5
