Viewing Stereoscopic 3D Images (Continued)

 

 

 

 

Press 3D MODE on the remote

 

6

 

 

 

 

 

 

Using 3D Viewing Mode

 

 

 

control to display the 3D MODE

 

 

 

menu.

Use the following procedure to project 3D images.

For operation of the 3D LCD shutter glasses and the 3D-video playback equipment, see the corresponding operation manual.

ENTER button

O/Q buttons

Info

•If “An invalid button has been pressed.” is displayed, a 3D-compatible signal is not being input. Check the output signal on the playback equipment.

7Press Q to set “DLP® Link™” to “On”.

8 Press ENTER to switch the mode and enable more natural 3D image viewing.

3D MODE button

Projecting 3D images

1Turn the projector on.

2Turn the 3D-video playback equipment on.

•Set the 3D-video playback equipment so that it outputs one of the signals listed in the Compatibility Chart in this operation

manual.

3Switch the Input mode of the projector to enable input of 3D

video signals.

4Operate the 3D-video playback

equipment and play back the 3D content.

5Turn the 3D LCD shutter glasses

on and place them over your eyes.

Warning!

•If the projector, 3D-video playback equipment, and 3D LCD shutter glasses are not properly set, you may experience eye strain in addition to not being able to view the images in 3D.

9 Press 3D MODE.

• The 3D MODE menu will disappear.

Note

•If the images are not displayed in 3D, repeat steps 6 to 8.

•You can also use “DLP® Link™” and “DLP® Link™ Invert” on the menu screen to change the 3D setting.

Ending 3D projection

1Press 3D MODE on the remote

control to display the 3D MODE menu.

2Press O to set “DLP® Link™” to “Off”.

3 Press 3D MODE.

• The 3D MODE menu will disappear.

52