
Problem | Check | Page |
|
|
|
Maintenance indicator on | • See “Maintenance Indicators”. | |
the projector illuminates |
|
|
or blinks in red. |
|
|
|
|
|
Picture is green on | • Change the input signal type setting. | |
COMPUTER (YPbPr)/ |
|
|
HDMI (YPbPr) |
|
|
|
|
|
Picture is pink |
|
|
(no green) on |
|
|
COMPUTER (RGB)/ |
|
|
HDMI (RGB) |
|
|
Picture is too bright and | • Image adjustments are incorrectly set. | |
whitish. |
|
|
The cooling fan becomes | • When temperature inside the projector increases, the cooling fan runs | |
noisy. | faster. | |
|
|
|
The lamp does not light | • The lamp indicator is illuminating in red. | |
up even after the | Replace the lamp. |
|
projector turns on. |
|
|
The lamp suddenly turns |
|
|
off during projection. |
|
|
|
|
|
The image sometimes | • Cables are incorrectly connected to the projector or the connected | |
fl ickers. | equipment works improperly. |
|
| • If this happens frequently, replace the lamp. | |
The lamp needs much | • The lamp will eventually need to be changed. | |
time to turn on. | While the remaining lamp life draws to a close, replace the lamp. |
|
|
|
|
Picture is dark. |
|
|
|
|
|
The remote control | • Operate the remote control while pointing it at the projector's remote | |
cannot be used. | control sensor. |
|
| • The remote control may be too far away from the projector. |
|
| • If direct sunlight or a strong fl uorescent lamp is shining on the |
|
| projector's remote control sensor, place the projector where it will not |
|
| be affected by strong light. |
|
| • The batteries may be depleted or inserted incorrectly. Make sure the | |
| batteries are inserted correctly or insert new ones. |
|
Appendix
67