Sharp PN-E802, PNE802 operation manual Preparing the Remote Control Unit, Installing the batteries

Preparing the Remote Control Unit

Installing the batteries

1.Press the cover gently and slide it in the direction of the arrow.

2.See the instructions in the compartment and put in the supplied batteries (R-6 (“AA” size) x 2) with their plus (+) and minus (-) sides oriented correctly.

3.Close the cover.

TIPS

•When the batteries become exhausted, replace them with new (commercially available) batteries.

•The supplied batteries (R-6 (“AA” size) x 2) may become exhausted quickly depending on how they are stored.

•If you will not be using the remote control for a long time, remove the batteries.

•Use manganese or alkaline batteries only.

Remote control operation range

The operation range of the remote control unit is approx. 16.4 feet (5 m) at an angle of approx 10° from the center to the top/ bottom/right/left of the remote control sensor.

	Remote
	control sensor
10°		16.4
		feet
10°	10°	(5 m)
10°

TIPS

•Do not expose the remote control unit to shock by dropping or stepping on it. This could lead to a malfunction.

•Do not expose the remote control unit to liquids, and do not place it in an area with high humidity.

•The remote control unit may not work properly if the remote control sensor is under direct sunlight or strong lighting.

•Objects between the remote control unit and the remote control sensor may prevent proper operation.

•Replace the batteries when they run low as this may shorten the remote control’s operation range.

•If a fluorescent light is illuminated near the remote control unit, it may interfere with proper operation.

•Do not use it with the remote control of other equipment such as air conditioner, stereo components, etc.

E14