Sharp R1870BK, R-1870 P a C K I N G I N S T R U C T I O N S, T I O N a L a C C E S S O R I E S

U N P A C K I N G I N S T R U C T I O N S

Unpacking and Examining Your Oven

Carefully remove oven from carton. SAVE THE CARTON AS IT MAY MAKE INSTALLATION EASIER.

Remove:

1. all packing materials from inside the oven cavity; however, DO NOT REMOVE

THE WAVEGUIDE COVER, which is located on the ceiling in the oven cavity.

Check to see that there are Installation Instructions, Wall Template and Top Tem-

plate. Read enclosures and SAVE the Operation Manual.

Hinges

Oven cavity

2. the feature sticker from the outside of the door, if there is one.

Latches	Door seals and
	sealing surfaces

Check the oven for any damage, such as misaligned or bent door, damaged door

seals and sealing surfaces, broken or loose door hinges and latches and dents inside the cavity or on the door. If there is any damage, do not operate the oven and contact your dealer or SHARP AUTHORIZED SERVICER.

See Installation Instructions for more details.

O P T I O N A L A C C E S S O R I E S

Two optional accessories are available for this oven.

1.Charcoal Filter (RK-220). This is required when hood exhaust is recirculated. See Charcoal Filter on page 26. To order filter replacement, if dealer does not stock this item, it can be ordered by calling 1-800-642-2122.

2.Filler Panel Kit. For use when the oven is installed in a 36-inch or 42-inch wide opening. The metal filler panels come in 3-inch wide pairs. One set is needed for a 36-inch opening and 2 sets for a 42-inch opening. White and black are available.

To purchase contact:	Modern-Aire Ventilating Corporation
	7319 Lankershim Blvd.
	North Hollywood, CA 91605
	Phone: (818) 765-9870
	Fax: (818) 765-4916

G R O U N D I N G I N S T R U C T I O N S

This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces risk of electric shock by providing an escape wire for the electric current.

WARNING – Improper use of the grounding plug can result in a risk of electric shock.

Electrical Requirements

Check Installation Instructions for proper location for the power supply.

The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more protected electrical supply. It is recommended that a separate circuit serving only the oven be provided.

The oven is equipped with a 3-prong grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded. DO NOT UNDER ANY CIRCUM-

STANCES CUT OR REMOVE THE GROUNDING PIN FROM THE PLUG.

Notes: 1. If you have any questions about the grounding or electrical instructions, consult a qualified electrician or service person.

2.Neither Sharp nor the dealer can accept any liability for damage to the oven or personal injury resulting from failure to observe the correct electrical connection procedures.

Radio or TV Interference

Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check position and signal of receiving antenna.

4