C L E A N I N G A N D C A R E
FAN
The fan will automatically start when heat rises from range surface units or burners and when convection, high mix, low mix or the broil settings are used. This protects the microwave oven from excessive tempera- ture rise. The fan will stay on until the temperature decreases. It cannot be turned off manually during this time.
For other uses, select either high or low speed.
PRECAUTIONS FOR PROPER USE:
1.DO NOT leave range unattended while using high temperatures. Automatic fan may start and provide excessive air to the surface units. This may cause spattering or boilover.
2.Avoid burning food.
3.Keep grease filters clean.
CHARCOAL FILTER
Charcoal Filter, Sharp Part Number
1.Disconnect power to the oven at the circuit breaker panel or by unplugging.
2.Remove 3 screws that secure louver.
3.Remove louver by inserting flat edge screwdriver over each tab depressing the tab down and moving louver away from unit.
4.Pull the louver away from the oven.
5.Slide Charcoal Filter into position on support tabs.
6.Push louver back into place and gently snap tabs into place by hand (engaging both the bottom and top tabs) and replace the 3 screws to secure louver.
LIGHT
1.To replace light bulbs, first disconnect power to the oven at the circuit breaker panel or by unplugging.
2.To release cover remove the screw on the light cover. (See illustration.)
3.Replace bulbs only with equivalent watt bulbs available from a Sharp Authorized Servicer or parts distributor. Bulbs are also available at most hard- ware stores or lighting centers. DO NOT USE A BULB LARGER THAN 30 WATTS.
4.Close light cover and secure with screw removed in step 2.
CAUTION: Light cover may become very hot. Do not touch glass when light is on. Do not use light for long time use such as a night light.
Light cover
Screw | Light bulbs |
|
OVEN LIGHT
Remove the louver per instructions
5.Slide the light cover forward and lift up.
6.Remove old light bulb and replace only with an equivalent watt bulb available from a Sharp Authorized Servicer or parts distributor. Bulbs are also available at most hardware stores or lighting centers. DO NOT USE A BULB LARGER THAN 30 WATTS.
7.Replace the oven light cover and charcoal filter, if used; push louver back in place (engaging both the bottom and top tabs) and replace the louver mounting screws.
Screw | Top tab |
Charcoal filter
Screw
Screw
Oven light
Louver
Bottom tab
27
