Sharp SJ-F676ST, SJ-F624ST operation manual Installation, Before using your refrigerator

Models: SJ-F676ST SJ-F624ST

1 12
Download 12 pages 46.55 Kb
Page 3
Image 3
INSTALLATION
or more
60mm
or more
60mm
90mm or more

INSTALLATION

WARNING

Do not install the refrigerator in a damp or wet location as this may cause damage to the insulation and a leakage. Condensation may also build on the outer cabinet and cause rust.

1 Keep adequate ventilation space around the refrigerator.

• The figure shows the minimum

required space for installing the refrigerator.

The amount of space around the refrigerator affects

the amount of power consumption.

• Insufficient spacing will Before using your refrigeratorManual backgroundManual backgroundManual backgroundManual background decrease cooling efficiency Manual backgroundManual background and increase energy Manual backgroundManual background consumption.Manual backgroundManual backgroundManual background This may reduce the life of the

unit and void warranty.

If using the refrigerator in the smaller space dimension than the below figure, it may cause the temperature rise in the unit, loud noise and failure.

The space between the rear of the refrigerator and the wall should be 60mm or more and less than 75mm.

If the space is wider than 75mm, you may get injured by touching compressor and its peripheral parts which are extremely hot during the operation.

Overall space required in use Manual background mm1180

1500 mm

2 Use the two front adjustable feet, to ensure that the refrigerator is positioned firmly and flat on the floor.

Manual background Adjustable foot

Free standing type

3 When right and left doors are not properly aligned, adjust using the adjustable feet.

When the left door is

When the right door is

raised.

raised.

Lower the foot

Lower the foot

at right side.

at left side.

(Until the adjustable foot on the other side is slightly off-ground.)

4 Remove the 4 screws of the cabinet lower part, and then set the foot cover (supplied inside the refrigerator compartment) with removed 4 screws.

Screw (4 screws)

Screw

Manual background Foot cover

5 Connect the power plug to a 230/240 volt. 10 amp. power point.

NOTE

Position your refrigerator so that the plug is accessible.

Keep your refrigerator out of direct sunlight.

Do not place next to heat generating appliance.

Do not place directly on the ground. Provide suitable stand.

If the mains power is switched on when the door is open, the door alarm will sound. Close the door to stop the alarm.

Before using your refrigerator

Clean the inside parts with a cloth soaked in warm water. If soapy water is used, wipe it off thoroughly with water.

3

Page 3
Image 3
Sharp SJ-F676ST, SJ-F624ST operation manual Installation, Before using your refrigerator