Warming Drawer Use

Electronic Touch Controls

Continuous On Mode

Press POWER to turn the Warming Drawer on and off. Signal light will indicate when unit is on.

To Select Desired

Temperature

Select temperature by pressing TEMP until indicator light is on next to desired temperature.

To select Desired Time

Select from five preset times or Continuous

On by pressing TIME until light is on next to desired time.

Use caution when selecting Continuous On. Unit will need to be turned off using the POWER key.

Preheating

POWER

On/Off

Temp.

90° Proof 125° Low 150° 175° Med. 200° 230° High

Time

1/2 Hour

1Hour

2Hours

3Hours

4Hours

Continuous On

When the Warming Drawer is in Continuous On mode, it will remain on until turned off manually. To avoid a fire hazard or burns, exercise caution when operating the unit in Continuous On mode. Touch POWER to turn the unit off.

Auto Shut-Off

Do not block the humidity vents on the back of the drawer front and along the left and right sides of the drawer. Excessive heat buildup can occur.

Rack

A wire rack is included to use for double stacking items.

The rack will fit from front to back or from side to side.

• Preheat with the rack in place.

Allow time for the drawer to preheat.

For best results, preheat your Warming Drawer according to the chart below before use. If you put hot food into a cool, confined area, any steam that is present will condense. If you preheat your Warming Drawer, there will be less chance of water due to condensation. Preheat times vary depending on the temperature setting.

Temperature

Settings

APPROXIMATE TIME

 

 

 

90˚

Proof

Preheat Not Required

125˚

Low

8 minutes

150˚

 

12 minutes

175˚

Medium

16 minutes

200˚

 

19 minutes

230˚

High

24 minutes

• The use of accessory attachments not recommended by

Sharp may cause injuries.

• Always place racks in desired position while drawer is cool.

If racks must be removed while Warming Drawer is hot, do

not let the potholder contact the heating elements.

• DO NOT USE aluminum foil to line any part of the

Warming Drawer. Using a foil liner could result in a fire

hazard, or the obstruction of the flow of heat and ventilation

air. Foil is an excellent heat insulator and heat will be

trapped underneath it. This trapped heat can upset the

performance of the Warming Drawer parts.

• DO NOT place more than 50 pounds in the drawer.

CAUTION Plastic containers or plastic wrap can melt if in direct contact with the drawer or a hot utensil. Items may melt and cause damage to the Warming Drawer or injury.

8