Manuals / Sharp / Computer Equipment / Projector

Sharp XG-SV200X, XG-SV100W specifications Connecting the Projector to a Computer

Models: XG-SV100W XG-SV200X

1 26

Download 26 pages 56.08 Kb

Page 12

Setting up the Projector Network Environment

Setting up the Projector Network Environment

1.Connecting the Projector to a Computer

Establishing a one-to-one connection from the projector to a computer. Using a commercially available LAN cable (UTP cable, Category 5, cross-over type) you can conﬁgure the projector via the computer.

1Disconnect the computer's LAN cable from the existing network.

A LAN cable being

connected to the network

2 Connect a commercially available LAN cable (UTP cable, Category 5, cross-over type) to the projector's LAN terminal and connect the other end of the cable to the computer's LAN terminal.

LAN cable

(cross-over type, commercially available)

3Plug the power cord into the AC socket of the projector.

4 Turn on the computer.

Info

Conﬁ rm that the LINK LED on the rear of the projector illuminates. If the LINK LED does not illuminate, check the following:

•The LAN cable is properly connected.

•The power switches of both the projector and the computer are on.

ON

This completes the connection. Now proceed to “2. Setting an IP Address for the Computer”.

-12

Image 12

Sharp XG-SV200X, XG-SV100W Connecting the Projector to a Computer, Setting up the Projector Network Environment

Contents

SETUP MANUAL Connecting Pin AssignmentsRS-232C Speciﬁcations and Commands Operating the Projector Using the PJLink TM ProtocolConnecting Pin Assignments COMPUTER/COMPONENT 1, 2 input and COMPUTER/COMPONENT output TerminalsHDMI Terminal Connecting Pin Assignments RS-232C Cable recommended connection D-sub 9 pin female connectorLAN Terminal LAN RJ-45 RS-232C Speciﬁcations and Commands Computer controlCommunication conditions Basic formatCommands RS-232C Speciﬁcations and CommandsP O W R RS-232C Speciﬁcations and Commands RS-232C Speciﬁcations and Commands RS-232C Speciﬁcations and Commands RS-232C Speciﬁcations and Commands 5 The Lamp Timer Reset command is available only in standby modeOperating the Projector Using the PJLinkTM Protocol The projector conforms with the PJLinkTM standard ClassSetting up the Projector Network Environment 1. Connecting the projector to a computer2. Setting an IP address for the computer 3. Setting up a network connection for the projector1. Connecting the Projector to a Computer Setting up the Projector Network Environment2. Setting an IP Address for the Computer Setting up the Projector Network EnvironmentSetting up the Projector Network Environment 6 Conﬁrm or change an IP address for the setup computerIP address Subnet mask Default gateway Do not input any values 3. Setting up a Network Con- nection for the Projector Setting up the Projector Network EnvironmentSetting up the Projector Network Environment Click the “Apply” buttonControlling the Projector via LAN Controlling the Projector Using Internet ExplorerConﬁrming the Projector Controlling the ProjectorControlling the Projector via LAN Status StatusSetting and Adjusting the Setting the SecurityProjector Settings & Adjustments Controlling the Projector via LANMaking General Settings for Setting for Sending E-mail when an Error OccursMail - Originator Settings Controlling the Projector via LANMail - Recipient Settings Access URLResetting the Lamp Timer of the Projector via LAN Resetting the Lamp Timer of the Projector via LAN Troubleshooting Communication cannot be established with the projectorTroubleshooting Troubleshooting