Setting up the Projector Network Environment
5Click “Internet Protocol Version 4 (TCP/IPv4)”, and click the “Properties” button.
1
2
6Confirm or change an IP address for the setup computer.
1Confirm and note the current IP address, Subnet mask and Default gateway.
Make sure to note the current IP address, Subnet mask and Default gateway as you will be required to reset them later.
2Set temporarily as follows:
IP address: 192.168.150.3
Subnet mask: 255.255.255.0
Default gateway: (Do not input any values.)
Note
•The factory default settings for the projector are as follows:
DHCP Client: OFF
IP address: 192.168.150.2
Subnet mask: 255.255.255.0
Default gateway: 0.0.0.0
7
After setting, click the “OK” button, and then restart the 
computer.
After confirming or setting, proceed to “3. Setting up Network Connection for the Projector”.
-14
