01/3/1 XL-3000W(A)2.fm
14
Basic Operation

- Setting the Clock -

Setting the Clock
This may be operated only with the remote control.
In this example, the clock is set for the 24-hour (0:00) display.
To confirm the time display when the power is on:
Press the CLOCK button.
The time display will appear for about 5 seconds.
Note:
The time will flash at the push of the CLOCK button when the AC
power supply is restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the Clock" from the beginning.
To change the 24-hour or 12-hour display:
1Press the CLOCK button and within 3 seconds, press
the MEMORY button.
2Within 1 minute, press the PRESET ( or ) button to
select 24-hour or 12-hour display and then press the
MEMORY button.
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
Note that this can only be set when the unit is first installed or it
has been reset. (Refer to step 3 under "If trouble occurs" on
page 25.)
3Within 1 minute, press the PRESET ( or ) button to
adjust the hour and then press the MEMORY button.
zWhen the 12-hour display is selected, "AM" will change au-
tomatically to "PM".
4Within 1 minute, press the PRESET ( or ) button to
adjust the minutes and then press the MEMORY button.
zThe hour will not advance even if minutes advance from "59"
to "00".
zThe clock starts from "0" second. (Seconds are not dis-
played.)
1 Clear all the programmed contents. [Perform step 3 under "If
trouble occurs" on page 25.]
2 Perform "Setting the Clock" from the beginning.