Sharp XL-DAB151PH(S) System connections, Aerial connection, Speaker connection, Black

System connections

Make sure to unplug the AC power lead before making any connections.

Right speaker

	TV
	Video cable
DAB/FM aerial	(not supplied)
	To video input socket
	Left
	speaker

	RED
	BLACK
	Wall socket
	(AC 220 - 240 V ~ 50/60 Hz)
MODEL NO.
XL-DAB151PH(S)	Label is located at the
HI FI COMPONENT SYSTEM
AC 220 - 240V 50/60Hz 45W
FREQUENCY RANGE : FM 87.5 - 108 MHz

DAB 174.928 - 239.200 MHz	bottom of the unit.
SERIAL NO.

MADE IN CHINA

92Lxxxxxxxxxxx

■Aerial connection

Supplied DAB/FM aerial:

Connect the DAB/FM aerial wire to the DAB/FM terminal and position the DAB/FM aerial wire in the direction where the strongest signal can be received.

Note:

Placing the aerial on the unit or near the AC power lead may cause noise pickup. Place the aerial away from the unit for better reception.

■Speaker connection

●Connect the black wire to the minus (–) terminal, and the red wire to the plus (+) terminal.

● Use speakers with an impedance
of 4 ohms or more, as lower
impedance speakers can damage
the unit.	Incorrect
● Do not mistake the right and the
left channels. The right speaker is
the one on the right side when you
face the unit.

●Do not let the bare speaker wires touch each other.

●Do not allow any objects to fall into or to be placed in the bass reflex ducts.

●Do not stand or sit on the speakers. You may be injured.

■Demonstration mode

●The first time the unit is plugged in, the unit will enter the demonstration mode.

●To cancel the demonstration mode, press the DEMO/ DIMMER button (remote control) during power stand- by mode. The unit will enter the low power consumption mode.

●If iPod or iPhone is docked, the unit will begin charging. “Charge Mode” will be displayed. Demonstration mode is invalid during charge mode.

●To return to the demonstration mode, press the DEMO/ DIMMER button again.

■Connecting iPod or iPhone to TV

Photo and video files from iPod or iPhone can be viewed by connecting the system to TV/monitor.

If the TV/monitor has a video input, connect it to the VIDEO OUT socket at the back of the unit and set the TV Out on the iPod or iPhone unit to “ON” position.

Note:

Please make sure to set iPod unit to either NTSC or PAL to match your TV signal. Please visit Apple’s homepage for further information.

6