52
XL-DV60
References
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorized SHARP dealer or service center.
"General

"Remote control

"DVD pla yer

Symptom Possible cause
The clock is not
set to the correct
time.
!Did a power failure occur? Reset the clock.
(Refer to page 21.)
When a button is
pressed, the unit
does not re-
spond.
!Set the unit to the power stand-by mode and
then turn it back on.
!If the unit still malfunctions, reset it. (Refer to
page 53.)
No sound is
heard.
!Is the volume level set to "0"?
!Are the headphones connected?
!Are the speaker wires disconnected?
!Is the TV or amplifier volume level set to "0"?
Noise is heard
during playback.
!Move the unit away from any computers or
mobile phones.
The power is not
turned on.
!Is the unit unplugged?
Symptom Possible cause
The remote con-
trol does not op-
erate.
!Is the AC power cord of the unit plugged in?
!Is the battery polarity correct?
!Are the batteries dead?
!Is the distance or angle incorrect?
!Does the remote control sensor receive
strong light?
Symptom Possible cause
No images are
displayed.
!Is the TV turned on?
!Is the input of TV switched?
!
The video mode may not match the jacks you
are using. Change the mode as follows.
While in the stop mode, press the SHIFT but-
ton and DIRECT/VIDEO MODE button on
the remote control a few times (see page 17) .
Even though a
disc is loaded,
"No Disc" is dis-
played.
!Is the disc loaded upside down?
!Is the disc very dirty?
!Does the disc satisfy the standards?
!Is the unit located near excessive vibrations?
Playback sounds
are skipped.
!Is condensation formed inside the unit?
The control but-
tons do not func-
tion. Music or
video playback is
interrupted.
!Is the disc very dirty?
!Does the disc satisfy the standards?
!Is the unit located near excessive vibrations?
!Is condensation formed inside the unit?
Pictures and
sound are
skipped.
!Is the disc very dirty?
!Is the unit located near excessive vibrations?
!Is condensation formed inside the unit?
The unit does not
operate even if
the power is on.
!Is a disc other than a DVD (region number 1
or ALL), video CD, audio CD, CD-R or CD-
RW loaded?
Images cannot
be played back.
(Sound is not
heard.)
!Is a disc other than a DVD (region number 1
or ALL), video CD, audio CD, CD-R or CD-
RW loaded?
!Is the disc very dirty?
!Is the disc loaded upside down?
!Is the optical pickup dirty?
!Is the TV input set to video (VIDEO1,
VIDEO2, etc.)?
!Is the unit turned on?